Skip to content

Power over Ethernet already runs your access points, cameras, and desk phones. Lighting is the next obvious load. With the AT-LED-24V-BULB Kit, a single PoE+ network drop can power a standard lamp, and you never have to touch a breaker panel.

Here's what the kit does, what you need, and how to set it up in four steps.

What is the AT-LED-24V-BULB Kit?

It's a PoE lighting kit built around the AT-LED-24V driver. The driver takes power from a PoE+ (IEEE 802.3at) port and converts it to 24V for an LED bulb. In the box:

  • AT-LED-24V driver, which converts PoE+ into 24V for the light
  • 24V LED bulb, made to work with the driver
  • Wireless wall switch that needs no wiring and no batteries

You wire the driver to a low-voltage outlet, plug in your lamp, and control it with the switch.

Why PoE lighting makes sense for IT teams

  • It runs on the network you already manage. If you can patch a drop, you can add a light.
  • No breaker panel, no high-voltage work. The lamp gets its power from the PoE+ port, not a new circuit.
  • The switch goes anywhere. It's battery-free and sticks to the wall with an adhesive tab, so there's no switch loop to run and no batteries to replace.
  • It's quick. The whole setup is four steps.

What you'll need

  • The AT-LED-24V-BULB Kit
  • A PoE+ (IEEE 802.3at) network port
  • A two-prong outlet with cover
  • A short run of 18 AWG wire
  • A lamp

Watch the 80-second install

See the full setup before you start, from picking the port to switching on the light. Press play and follow along.

▶  Watch on YouTube

How to set it up in four steps

  1. Pick your port. Choose the Ethernet drop you want to use. It must be PoE+ (IEEE 802.3at).
  2. Wire the driver. Remove the wall jack and wire the AT-LED-24V driver to the outlet. The stripped wires push into the + and – ports.
  3. Pair the switch. Connect the driver to PoE. Hold the button on the driver until the green light comes on, then press the wireless switch until the light turns off. That's it, they're paired.
  4. Light it up. Install the outlet, plug in the lamp, and screw in the bulb from the kit. Mount the switch with the adhesive tab.

Where it fits

  • Offices and meeting rooms: put desk and side lamps on the network instead of another circuit.
  • Smart buildings: a natural fit for spaces already built around PoE.
  • Retrofits and rentals: add light where opening walls for electrical work isn't an option.
  • Anywhere with a network drop: if there's PoE+, you can add a lamp.

Quick answers

What kind of PoE do I need? PoE+ (IEEE 802.3at) from your switch or injector.

Can I use a regular household bulb? No. The outlet in this setup carries 24V from the driver, so use the 24V LED bulb included in the kit.

Does the switch need wiring or batteries? Neither. It's battery-free and mounts anywhere with the included adhesive tab.

Ready to light a room from a network drop?

Get the driver, bulb, and battery-free switch in one kit.

Shop the AT-LED-24V-BULB Kit


Ready to Shop?

Need to Speak with an Expert?

Need to Speak with an Expert?

Book Here